User's Manual

ManualsBrandsNINGBO DOOYA MECHANIC & ELECTRONIC TECHNOLOGY ManualsElectronicsEmitter

Fucntion instructionTechnical specification

Input voltageᱶ3V

Transmitting frequencyᱶ433MHz

Transmitting powerᱶ10 milliwatt

Operating temperatureᱶ-10

C—50

Transmssion distanceᱶ200 meters open officeᱨ

35 meters on two walls

DC1530 is single-channel double control emitter

Notice: transmitter do not exposed to moisture and strike, so as not to affect life.

When you use transmitter, if found emission distance obviously short or less sensitive,

please change another same new battery. Please have batteries for recycling.

CAUTION

RISK OF EXPLOSION IF BATTERY IS REPLACED

BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING

TO THE INSTRUCTIONS

DC1530

Back side

DC1530

Single - channel

double control emitter

DC1530

EmitterSpecification

Version NO. : A/00

Type specification

Technical support

Up button

Stop button

Down button

Setting button

Up button

Stop button

Down button

Setting butto

During the settings,the time between

two operation must be shorter than

4s,otherwise it will quit the setting

Additional

function

Additional

function

Matchable R tubular motor setting up

Additional

function

Matchable DC1680 setting up

Matchable DC136 setting up

Power on

Sound from motor

hear long sound

Power on

Press (up+down)×1

at the same time

Indicator

flashing

Indicator long

flashing

Indicator flashing

then extinguished

Setting

is ok

Setting

is ok

During the settings,the time between

two operation must be shorter than

6s,otherwise it will quit the setting

During the settings,the time between

two operation must be shorter than

10s,otherwise it will quit the setting

Up×1

Down×1

Delete all the datas of the motor and

the new emitter has been programmed.

Beep once Beep once

Set up is ok.

The up button control

the motor clockwise

Set up is ok.

The down button control

the motor clockwise

Setting button×1

DC136 DC136 DC136 DC136 DC136

Stop×1

DC1680 DC1680 DC1680 DC1680 DC1680

Indicator

flashing

Indicator long

flashing

Indicator flashing

then extinguished

Stop×1Up×1

Run or beep

for hint

Run or beep

for hint

Up×1

P2×1P2×1

a way b way

Summary of content (2 pages)

PAGE 1
A Matchable R tubular motor setting up Additional function Up×1 During the settings,the time between two operation must be shorter than 4s,otherwise it will quit the setting DC1530 Emitter Specification P2×1 Sound from motor hear long sound P2×1 Beep once Down×1 Power on Type specification b way Up button Run or beep for hint OK During the settings,the time between two operation must be shorter than 6s,otherwise it will quit the setting Matchable DC1680 setting up Additional function Pres
PAGE 2
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.