Getting Started Guide

QUICK S
FCC ID: 2ABHA0059
TART GUIDE
TRUE WIRELESS EARBUDS
GETTING STARTED
7
2
3
1
6
5
4
R
L
1 Micro USB charging port
2 Charging Case LED indicators
3 Charging Case Power Button
（For checking power only)
4 Left earbud LED indicator
5 Left control button
6 Right earbud LED indicator
7
Right control button
Left Earbud /
Right Earbud
Pause/Play/Answer Call/End Call
— Charge the charging case, with the included micro
USB cable for 2 hours. The LED indicator will be lit red during
charging and turned off after fully charged
Do not charge longer than suggested time. Do not charge overnight.
CHARGING YOUR CASE
CHARGING YOUR EARBUDS
— Place Right and Left Earbuds in charging case
— Charging case LED indicator (2) will illuminate Blue and the
earbud LED indicators (4, 6) will illuminate Red, indicating that
the earbuds are charging properly. When Earbuds LEDs (4, 6)
turns off, earbud batteries are fully charged.
MONO MODE
(SINGLE EARBUD USE)
— Remove earbud from charging case
— Once earbud is powered on, It will automatically
proceed to PAIRING
— E
— Remove both earbuds from charging case
and close each other
arbuds will automatically link together after
a few seconds, and earbuds will have a tone
One earbuds will flash red and blue,
another earbuds will flash blue only.
— Once
Note: Please doule press the control
button of one earbuds to make both
earbuds pairing each other if they still not
paired automatically after 20 seconds.
Earbuds are linked together you may
proceed to pairing with your mobile device.
STEREO MODE
(DUAL EARBUD USE)
PAIRING
*Note: Once earbuds have been initially paired successfully with
your mobile device, they will automatically pair the next time
— Enable Bluetooth search mode on
your mobile device and search for
pairing name “ Tempo Earbuds ”
it on your mobile phone.
Once the earbuds are successfully
paired, a notification will
sound .
— Now you can enjoy your true
wireless Bluetooth Earbuds.
and select
TWS-i7
OPERATING BLUETOOTH EARBUDS
Function Operation
Power On
Model: SL319
Item No.: XXXX
Capacity(Cradle): 350mAh / 3.7V (1.295Wh)
Capacity(Earbuds): 50mAh / 3.7V (0.185Wh)
Input: 5V/60mA (Earbuds)
Input: 5V/300mA (Cradle)
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including
interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Note:This equipment has been tested and found to comply with
the limits for a class B digital device,pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence
energy and,if not installed and used in accordance with the
instructions,may cause harmful interference to radio
communications.However,there is no guarantee that interference
will not accor in a particular installation.if this equipmemt does
cause harmful interference to radio or television reception,which
can be determined by turning the equipment off and on,the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from
that to which the receiver is connectec.
Made in China
Press (5) or (7) for 3 seconds or
remove the earbuds from
charging case
Power Off
Press (5) or (7) for 3 seconds or
place the earbuds in the charging
case
Play/Pause Single press (5) or (7)
Answer
Reject
Earbuds LED indications (4) & (6)
Power On
Red and Blue LED will flash altemately
Link Mode Flashing Blue + Red
Paired Successfully Flashing Blue
Power Off LED Off
Earbuds in Cradle
Charging Solid Red
Fully Charged
LED off
Charging Case See CHARGING YOUR CASE
Single press (5) or (7)
Press (5) or (7) for 2 seconds
they are powered on.
FCC STATEMENT
— Please remove the insulating trip before charging earbuds.
Insulating trip
• Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement. The devicecan be used in portable exposure
condition without restriction