User's Manual



LED



ON OFF



BT SPEAKER



OFF ON



Product Speciﬁcations

Model：

Power Output：3W X 1

SNR: ≥70dB

Frequency：20HZ-20KHz

Input：DC5V/300mA

Impedance：4Ω

Battery : 300mAh



ON OFF



Using Bluetooth with the SL038

Bluetooth Cube Speaker with Rubber Band

SL038

Slide the ON/OFF switch on the speaker to the ON position.

Open your divce bluetooth mode

“BT SPEAKER” should appear on your device.

If “Not Connected” or similar message appears,

select “BT SPEAKER”” to connect.

Once paired, You can then stream audio to the speaker.

CHARGE UNIT BEFORE USE

To charge the battery connect the larger plug of the

included USB charging cable to the powered USB port

of USB/AC adapter.

PAGE 1
Bluetooth Cube Speaker with Rubber Band Using Bluetooth with the SL038 1 LED 2 ON OFF Slide the ON/OFF switch on the speaker to the ON position. Open your divce bluetooth mode BT SPEAKER 3 OFF ON 4 Product Specifications Model：SL038 Power Output：3W X 1 SNR: ≥70dB Frequency：20HZ-20KHz “BT SPEAKER” should appear on your device. If “Not Connected” or similar message appears, select “BT SPEAKER”” to connect. 5 Once paired, You can then stream audio to the speaker.
PAGE 2
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.