User Manual

Ningbo COMEN Electronics Technology Co.,Ltd
ADRESSE: No.599 Jinda Road, Zhenhai Economic Development Zone,NINGBO,CHINA
TEL:[phone] FAX:[phone]
E-mail: [e-mail]
HTTP: www.comen.com.cn
PA-USA-01W Input: 110V to125VAC/60Hz
Maximum Resistive Load:1875watt
Maximum Motor Load:1/3hp
Maximum Tungeten Load:1000watt
Wifi: 2.4GHz / 802.11b/g/n
Remote: 433.92MHz / 30meters
● Environment：0~30℃
● System：iOS 7.0 new , Android 4.0 new
● Wi-Fi Features: Supports standard IEEE 802.11b/g/n networks.
Easy opeartion one key setup, turn on/off multiple equipments.
Control via multiple terminals- smart phone/ tablet anywhere, local WiFi network or outer internet via 3G 4G, as well as LAN
network without internet.
Free icomen Apps for Android and iOS systems
5.
Caution:
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.