Installation Instructions

Plank 5000 mAh Bamboo
Wireless Power Bank
When Charging, LED Indicator will
glittering blue light. Once fully charged
all LED lights will be illuminated.
Press ON/OFF Button 3 seconds and wait for
LED flash from RED to GREEN for one time.RED
indicator will be on.When RED light illuminate,
place wireless charging device on wireless
charging pad.LED will illuminate GREEN when
charging.if no device was detected on wireless
pad over 15 seconds,it will turn off wireless
charging automatically.After 36 seconds,the
power bank is off.
14.
15.
Environment
temperature
for
operating:
~
113°
While
charging;
While
discharging.
16.
Environment
temperature
for
storage:
Storage
in -4° ~
product
needed
recharge battery every
month;
Storage
in
product
needed
recharge battery
6
monthes.
A
void
overdischarge
of the
battery
can
help
keeping
the
safty
performance
of the
product.
17.
Do not use
or store in extreme temperatures.
Avoid exposure to direct sunlight, and do not
leave in a car. High temperature will shorten
the service life and can result in fire or exposion.
18.
Please use the
product
in
the
prescribed
environment to maintain the best
performance
of the
product,
Using
or
recharging battery
in
high
temperature
may
shorten the service life
or result
in
overheating
and
explosion.
If
this
product
not used for a
long
time,
need to
be
charged
at least
every
5-6
months.
You must remove attachments prior to use.
.
Plan
k
3
~
113°
50
and fire.
113°
-4° ~
95°
FCC Warning Statement
Changes or modifications not expressly approved by
the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
The distance between user and products should
be no less than 20cm