User's Manual

Charging Port Open the rubber cap.
Insert the plug into the
socket.
There are safety risks when learning to ride the S Kids. You must read the Safety Instructions and follow
the New Rider Tutorial in the app before your first ride.
For your safety, your S Kids is not activated at this time and will beep occasionally or have a voice
reminder after powered on.
Until activated, the S Kids maintains a very low riding speed and steering sensitivity, and should not be
ridden. Install the app on your mobile device (with Bluetooth 4.1 or above), connect to the S Kids with
Bluetooth, follow the app instructions to activate your S Kids and follow the training procedures.
Scan the QR code on the left to download the app.
1 Install the app and register or log in. 2 Power ON the S Kids. The Bluetooth icon blinking
indicates the S Kids is waiting for a connection.
4 Follow the prompts to watch the Riding Safety video,
complete the New Rider Tutorial, and then activate
the S Kids.
3 Click Device > Search Vehicle to connect.
Your S Kids will beep once or have a voice prompt
when the Bluetooth connection is successful.
Segway-Ninebot App
1 Slide the steering bar onto
to the mounting bracket.
2 Install the two screws. Tighten
securely with the included hex
wrench.
3 Peel off the back glue. Press the rubber cap
onto the steering bar until it snaps in place.
WARNING
• Do not connect the charger if the charge port or charge cable is wet. The battery pack is only to be charged by adults.
• Your S Kids is fully charged when the LED on the charger changes from red (charging) to green (trickle charge).
Close the rubber cap when not charging.
6 Active your S Kids4 Assembling Your S Kids
5 Charging
6 7