24-01-2006 Nilfisk-ALTO E 130.1, E 140.
Printed in China Copyright © 2006 Nilfisk-ALTO
EN Index 1 2 3 4 5 6 7 8 9 10 Safety precautions and warnings .............................................3 Description ...............................................................................4 Before you start using your pressure washer ...........................5 Operating your pressure washe ...............................................6 Fields of Application and Working Methods...............................................................9 After using your pressure washe ..................
EN Extension cables should be of a watertight construction and comply with the below-mentioned requirements for length and cable dimensions. 1.0 mm² 1.5 mm² 2.5 mm² max. max. max. 12.5 m 20 m 30 m Cable connections should be kept dry and off the ground. Mains power connection The following should be observed when connecting the high pressure washer to the electric installation: Only connect the machine to an installation with earth connection.
3 Before you start using your pressure washer 3.1 Mounting of trolley handle (models with trolley handle) EN 1. Remove the label on top of machine. 2. Push down the trolley handle (12) into the machine. Secure the handle by tightening the 2 screws. 3. Mount the hose hook (14) on the handle (3 screws). Note: the hose hook can be mounted on the front as well as on the back. Front position is to be used if the product is used together with a special wall hook for wall storage. 3.
EN 4 Operating your pressure washer 4.1 Connection of high pressure hose (models without hose reel) 1. Mount the high pressure hose on the outlet (3). 4.2 Mounting of spray lance and Click & Clean nozzles 1. Push the spray lance (6) into the spray gun (7) and screw it on. Note: The spray lance (6) has a built-in low pressure nozzle that can be used for flushing away dirt. 2. Attach the nozzle.
4.3 Water connection An ordinary 1/2" garden hose of min. 5 m and max. 25 m will be suitable. NOTE: Connection to the public mains according to regulations. 4.4 Start and stop of the machine (when connected to a water supply) The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. IMPORTANT: Point the nozzle at the ground. 1. Check that the machine is in upright position. NOTE: Do not place the machine in high grass! 2. Release the trigger lock. 3.
EN 4.5 Start the machine (when connected to open containers (suction mode)) The washer can take in water from a rain water tank as an example. The hose for the water supply must not be too long, approx. 5 m. Make sure that the water tank is not placed on a lower level than the machine. 4.6 Pressure regulation on the TORNADO® PRnozzle Højtryk 1. Place the other end of the water hose in the water tank. Use an external filter if the water contains impurities. 2. Press the start/stop switch "I". 3.
5 Fields of application and working methods EN 5.1 General Efficient high presure cleaning is achieved by following a few guidelines, combined with your own personal experience of specific cleaning tasks. Accessories and detergents, when correctly chosen, can increase the efficiency of your pressure washer. Here is some basic information about cleaning. 5.1.1 Detergent and foam Foam or detergent should be applied onto dry surfaces so that the chemical product is in direct contact with the dirt.
EN 5.2 Typical fields of application Below you will find a description of a lot of cleaning tasks which can be solved by a pressure washer from Nilfisk-ALTO in association with accessories and detergents. Task Accessories ‘Click Cleaning method & Clean’ Car Car nozzle, auto brush, underchassis nozzle, Foam sprayer, Car Combi Cleaner 1. Apply Car Combi Cleaner with the foam sprayer. Always start from the bottom and work upwards. Let Car Combi Cleaner act for at least 5 min. 2.
6 After using your pressure washer 6.1 Storing the washer 6.2 Winding up of electric cable and high pressure hose The machine should be stored in a frost-free room! Pump, hose and accessories should always be emptied of water prior to storing as follows: 1. Stop the machine (press the start/stop switch “O” (1) and detach water hose and accessory. 2. Restart the machine and activate the trigger. Let the machine run until no more water runs through the spray gun. EN 3.
EN 6.3 Storage of accessories A B B A B D C C D E The standard accessories (spray gun and spray lance (a), nozzles (b) foam sprayer (c)) can be stored on the pressure washer. The nozzle cleaning tool (d) and a Click & Clean brush (e) can also be stored on the product. E 7 Maintenance WARNING! Always disconnect the electrical plug from the socket prior to maintenance or cleaning.
7.1 Cleaning of water inlet filter Clean the water inlet filter regularly once a month or more frequently according to use. Carefully loosen the filter with a pair of pliers and clean it. Check that it is intact before re-mounting it. The inlet filter must always be fitted inside the water inlet pipe to filter out sand, limestone and other impurities, as they will damage the pump valves. CAUTION: Failure to fit the filter will invalidate the guarantee. 7.
EN 8 Trouble-shooting To avoid unnecessary disappointments, you should check the following before contacting the NilfiskALTO service organization: Symptom Cause Recommended action Machine refuses to start Machine not plugged in Defective socket Fuse has blown Defective extension cable Plug in machine. Try another socket. Replace fuse. Switch off other machines. Try without the extension cable. Fluctuating pressure Check that hoses and connections are airtight.
9 Further information 9.1 Recycling the washer Make the old cleaner unusable immediately. 1. Unplug the cleaner and cut the electric cable. Do not discard electrical appliances with household waste. EN cal and electronic appliances, used electrical goods must be collected separately and recycled ecologically. Contact your local authorities or your nearest dealer for further information. As specified in European Directive 2002/96/EC on old electri- 9.
EN 9.3 Accessories Only use original accessories. Click & Clean Car nozzle Special nozzle for enameled surfaces. Optimal distance: 30 - 50 cm. Click & Clean Undershassis nozzle 90° angled special nozzle for undercarriage and wheel arches. Integrated guide shoes. Click & Clean Multiangle adaptor Adjusted in angles from 0° - 90° for better working posture and cleaning of hard to get at places as for instance barrels or the underside of the lawn mower. Fits all nozzles.
EN Detergents Stone & Wood Cleaner For flagstones, brick- and woodwork. Suitable for moss and algae. Plastic Cleaner For plastic and synthetic materials such as garden furniture. Metal Cleaner For cleaning of metal such as garden tools. Car Combi Cleaner For cars etc. With rinsing wax. Alu Cleaner For surfaces of aluminium. Applied with an atomizer. Oil & Grease Cleaner For cleaning of grease and oil on motors for instance. Applied with an atomizer.
FRANCE Nilfisk-ALTO ALTO France SAS Aéroparc 1 19 rue Icare 67960 Entzheim Tel.: +33 3 88 28 84 00 Fax: +33 3 88 30 05 00 E-mail: info@nilfisk-alto.fr www.nilfisk-alto.com http://www.nilfisk-alto.com HEAD QUARTER DENMARK Nilfisk-Advance Group Sognevej 25 DK-2605 Brøndby Tel.: +45 4323 8100 Fax: +45 4343 7700 E-mail: mail@nilfisk-advance.dk SALES COMPANIES GERMANY Nilfisk-ALTO Division of Nilfisk-Advance AG Guido-Oberdorfer-Strasse 10 89287 Bellenberg Tel.
