User manual

C365
8
11/2010
ATTIX 115-01 / ATTIX 125-01
GB
Primary lter shaker
Depending on the quantity of dust cleaned up, shake the main
lter by means of the knob “3” (Fig. 4).
WARNING!
Stop the vacuum cleaner before using the lter shaker.
Do not shake the lter while the vacuum cleaner is on,
as this could damage the lter.
Wait before restarting the vacuum cleaner, to allow the dust to
settle.
Emergency stopping
Turn the switch “1” (Fig. 4) to “0” position.
Emptying the dust container
WARNING!
■ Before proceeding with these operations, turn the
vacuum cleaner off and disconnect the plug from
the power socket.
■ Check the class of the vacuum cleaner.
Before emptying the container it is advisable to clean the lter
(see “Primary lter shaker”).
■ Standard version is not suitable for vacuuming
hazardous dust
▪ Release the dust container (2 , Fig. 1) using lever (3,
Fig. 1), then remove and empty it.
▪ Make sure the seal is in perfect condition and
correctly positioned.
▪ Place the container back in position and secure it
again.
Plastic bag
You can use the plastic bags supplied by our sales network
(Fig. 6).
Liquids vacuuming
WARNING!
Check that the vacuum cleaner is equipped with
liquids mechanical stop.
■ The lter element will be wet after liquids have been
vacuumed.
A wet lter element can quickly become clogged if the
vacuum cleaner is then used to vacuum dry substances.
For this reason, make sure that the lter element is dry
or replace it with another one before using the vacuum
cleaner for dry materials.
Controls and indicators
Figure 4
1. Motor start/stop switch
2. Power indicator
3. Manual lter shaker knob
Figure 5
1. Inlet
Inspections prior to starting
Prior to starting, check that:
■ the lters are installed;
■ all the levers are locked in place;
■ the vacuum hose and tools have been correctly tted to
the inlet (1 - Fig. 5);
WARNING!
Do not use the vacuum cleaner if the lter is faulty.
Starting and stopping
Figure 4
WARNING!
Lock the castor brakes (1) before starting the vacuum
cleaner.
■ Turn the switch “1” (Fig. 4) to “I” position to start the
vacuum cleaner.
■ Turn the switch to “0” position to turn the vacuum cleaner
off.
Vacuum cleaner operation
WARNING!
The air speed in the suction tube must not be less
than 20 m/s.
WARNING!
Consult the “Troubleshooting” chapter if faults occur.