Operation Manual

ENGLISH INSTRUCTIONS FOR USE
18
SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5 - 9097054000
02/2007
05/2015
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Disconnect the battery connector (12).
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be dened by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorised Service
Center.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Tank and vacuum grid with oat cleaning, and cover gasket check
Chemical Mixing System cleaning and draining (optional)
Squeegee blade check
Solution Filter Cleaning
Vacuum system motor lter cleaning
WET battery uid level check
Squeegee blade replacement
Brush motor carbon brush check or replacement (1)
Vacuum system motor carbon brush check or replacement (1)
Drive system motor carbon brush check or replacement (only for
SCRUBTEC 545BL, 553BL and BOOST 5)
(1)
Vibration-dampers replacement (only for BOOST 5) (1)
(1) This maintenance procedure must be performed by Nilsk authorised Service Center.
MACHINE WORKING HOUR CHECK
(Only if the machine is equipped with hour counter)
1. Turn the ignition key (80) to “I”.
2. Press the push-button (73) and read on the hour counter (79) the total number of working hours (scrubbing/drying) performed
by the machine.
3. Press the push-button (73) again.
4. Turn the ignition key (80) to “0”.