Operation Manual
USER MANUAL ENGLISH
9099636000 - SCRUBTEC 343.2 15
Squeegee lifting
Lift the squeegee as indicated below:
1. Grasp the handlebar (2), lower it until the rear wheel (7)
touches the oor (A, Fig. 3) then engage the squeegee in
lifted position (B).
A
B
clik
Figure 3
P100642
MACHINE OPERATION (SCRUBBING/DRYING)
1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the oor.
3. If necessary, adjust the solution quantity by using the push-button (65).
CAUTION!
To avoid damaging the oor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the push-buttons (61).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the push-buttons (61).
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Nilsk suggests to go near the walls with the right side of
the machine as shown in gure 4.
A
A
B
Figure 4
P100643
CAUTION!
In case of brush/pad-holder motor overload, due to foreign bodies which prevent them from turning, or to
excessively aggressive oors/brushes, the safety system stops the brush/pad-holder after about one minute of
continuous overload.
The overload is shown by the three battery LEDs (64) ashing simultaneously.
To start scrubbing again after a brush/pad-holder stop due to overload, stop the machine by turning the switch
(62) to “0”. Start the machine by turning the switch (62) to “I”.