Operation Manual

USER MANUAL ENGLISH
SCRUBTEC 234C - 9099346000 13
BRUSH CLEANING
CAUTION!
It is advisable to wear protective gloves when
cleaning the brush because there may be sharp
debris.
WARNING!
Moving parts - Disconnect the plug from
the electrical mains before performing any
maintenance procedure on the machine.
Disassembly
1. Manually remove the screw (A, Fig. 7) by turning it
clockwise.
2. Remove the brush (B) from the deck.
3. Clean the brush with water and detergent.
4. Check the brush bristles for integrity and wear; if
necessary, replace the brush.
Assembly
5. Insert the brush with the hub guides (C, Fig. 7) on the drive
shaft (D) as shown in the gure.
6. Manually tighten the screw (A) by turning it counter-
clockwise to fasten the brush (B) to the drive shaft.
A
B
D
C
Figure 7
P100518
WARNING!
If the machine is not perfectly assembled it can cause damages to people and properties. Always check that all
components are assembled before starting the machine. Carefully inspect the machine before using it.
Available cylindrical brushes and their relevant application guides (suggestions only)
Types of brushes available NYLON Aglite Grit
Concrete
Terrazzo oor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles