Operation Manual

ENGLISH USER MANUAL
10 SCRUBTEC 234C - 9099346000
MACHINE OPERATION (SCRUBBING/DRYING)
1. Prepare the machine as shown in the previous paragraph.
2. Clean or vacuum the oor to remove any debris.
3. Connect the power supply plug (7) to the electrical mains.
WARNING!
Before connecting the power supply plug to
the electrical mains, check that frequency and
voltage, shown on the machine serial number
plate (26), match the electrical mains voltage.
4. Turn the main switch (2) to “I”, to turn on the brush motor.
5. Turn the switch (3) to “I”, to turn on the vacuum system
motor.
6. Turn the pump switch (4) to “I”, to turn on the solution ow
to the brush.
7. Press the pedal (Fig. 3) to lower the brush and squeegees
on the oor.
8. While keeping the hands on the handlebar, start the
machine by pressing the brush switches (6) and then start
scrubbing/drying the oor.
9. With the switch (5) adjust the solution ow according to the
type of cleaning to be performed.
• The switch is not pressed ( ): when the oors to
be cleaned are not very dirty; in this condition, the
machine autonomy is 10 minutes approximately.
• The switch is pressed ( ): when the oors to be
cleaned are dirty or very dirty; in this condition, the
machine autonomy is 7 minutes approximately.
10. For a better result, the machine must run at a low speed.
11. In case of tough dirt, wash the oor thoroughly by turning
the vacuum system switch (3) to “0”, then wash the oor
again and then collect the liquids by turning the vacuum
system switch (3) to ON.
CAUTION!
To avoid damaging the oor surface, do not use
the brush without the solution and, when the
machine is not operating, stop the brush.
12. At the end of the work, release the switches (6), turn
the main switch (2) to “0”, then lift the brush and the
squeegees with the pedal (Fig. 4).
Figure 3
P100514
Figure 4
P100515