User's Manual

OPERATION

Example include:

• Dropping a motorized screen

• Activating a television lift

• Turning on a voltage controlled switching device (e.g.: Niles AC-3 voltage controlled

switched outlet)

INSTALLATION

Simply plug a cable with a 3.5mm plug (tip=positive, sleeve=ground)

into the jack labeled “12VDC/200mA OUTPUT”. Connect the other end

of the cable to the device that will be triggered or a activated (Figure

8).“12VDC/200mA OUTPUT”. Connect the other end of the cable to the

device that will be triggered or activated (Figure 8).

POWER STATUS – INTRODUCTION

To properly wire an IntelliPad to the MSU250, refer to Figure 5

By providing 3-30 volt AC/DC to the status input jack of your MSU250

you can send a status signal to sensors or an IntelliPad without running any additional wiring. Built

into the MSU250 is a Niles status signal generator. When the MSU250 sees 3-30 volt AC/DC at the

status jack it broadcasts a status signal over your existing IR sensor wires. Any sensor or IntelliPad

Figure 8

(CONTINUED ON NEXT PAGE)