Users Manual

screw
unscrew
（counter-clockwise）
（clockwise）
Connectors must be screwed tightened
Dew
Insert tissue
and wipe
to remove
the dew
Cable Wire
Do not suspend light string by fixing only both ends
of light strings. Unless cable wire(not included),
rope(not included) was used to support light string,
Please use zip tie(not included), twist tie(not included)
or rope(not included) to fix each bulb onto the cable
wire through eyelet hole on socket.
END
SKETCH 1.
（SKETCH 1.）
SKETCH 2. SKETCH 3.
1. The lights do not come on at all: (SKETCH 3.)
a) Make sure the wall outlet and circuit breaker are on.
b) Make sure all connectors are well connected and tightened.
2. One or more of the lamps has burned out. (SKETCH 1.)
a) Disconnect power to the string light. Remove affected lamp by gently gripping lamp and then turning in a
counter-clockwise direction. Replace lamps only with spare lamps provided. Align the groove on the socket with the
bolt on the lamp, then gently insert the lamp into the socket. Turn the lamp in a clockwise direction until fully seated.
3. If lamps look foggy, moisture might be inside of bulb cover and result in a foggy look if bulb cover was not screwed
tightened into lamp socket. To remove the moisture, just use remove the bulbs by following steps of replacing bulbs
and use tissue paper to wipe off the moisture. (SKETCH 1. and SKETCH 2. )
9.5 Watts max,
19 Watts max total.
0.39
Watts max S14 type lamp (provided with product).
0.39W MAX
WARNING:
1. To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between
the antenna of this device and all persons.
2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.