Setting Guide (Video Edition)
Table Of Contents
21
Settings
Picture Quality, Continued
21
ISO SensitivityISO Sensitivity
Videos recorded in modes P, S, and A are shot using auto ISO sensitivity
(ISO AUTO). You can, however, select an upper limit to prevent the cam-
era choosing too high a value. In mode M, you also have the option of
adjusting ISO sensitivity manually.
■ Modes P, S, and A.
The camera adjusts ISO sensitivity automatically in response to shoot-
ing conditions, choosing from values of from ISO64 to Hi2.0; the cho-
sen value is shown in the shooting display and control panel.
■ Mode M
Auto ISO sensitivity control can be enabled or disabled by holding the
S button and rotating the sub-command dial; the display shows
ISO AUTO when auto ISO sensitivity control is enabled and ISO when
it is disabled. If desired, auto ISO sensitivity control can also be en-
abled or disabled using [ISO sensitivity settings]> [Auto ISO control
(mode M)] in the video recording menu.
When auto ISO sensitivity control is disabled (i.e., when ISO appears
in the shooting display and control panel), ISO sensitivity can be man-
ually set to values between ISO 64 and Hi 2.0 by holding the S but-
ton and rotating the main command dial. If desired, ISO sensitivity
can also be adjusted using [ISO sensitivity settings]> [ISO sensitivity
(mode M)] in the video recording menu.
Your selection will be shown in the shooting display and control panel.
S button
■ Maximum Sensitivity
To prevent auto ISO sensitivity control setting ISO sensitivity too high,
you can use the [ISO sensitivity settings]> [Maximum sensitivity]
option in the video recording menu to select an upper limit from val-
ues between ISO 200 and Hi 2.0.
The maximum ISO sensitivity for videos recorded with [ON] selected
for [Electronic VR] in the video recording menu is ISO 25600.
The selected setting applies in modes
P
,
S
, and A and in mode
M
when
[
ON
] is selected for [
Auto ISO control (mode M)
].
Cautions: Auto ISO Sensitivity Control
• At high ISO sensitivities, “noise” (randomly-spaced bright pixels, fog, or lines) may increase. Noise can be
reduced by selecting [High], [Normal], or [Low] for [High ISO NR] in the video recording menu (028).
• At high ISO sensitivities, the camera may have diculty focusing.
• The foregoing can be prevented by choosing a lower value for [ISO sensitivity settings]> [Maxi-
mum sensitivity] in the video recording menu.
• The minimum values available for [Maximum sensitivity] and [ISO sensitivity (mode M)] when
[HLG] is selected for video tone mode are ISO 800 and 400, respectively.
• The minimum values available for [Maximum sensitivity] and [ISO sensitivity (mode M)] when
[N-Log] is selected for video tone mode are ISO 1600 and 800, respectively.
ii-button menu-button menu
4
Camera controlsCamera controls
4
Other menusOther menus
4