Setting Guide (Auto Capture Edition)

Table Of Contents

Problems and Solutions

There is no guarantee that the camera will perform perfectly according to the trigger criteria selected.

We recommend that you take a number of test shots beforehand to confirm that trigger criteria

function as expected. This section lists some problems you may encounter and their solutions.

More Photos Than Expected

[Motion] selected for [Capture criteria]:

Try selecting higher values for [Speed] and [Subject Size].

Lighting changes during long outdoor sessions may result in auto capture being triggered by

shadows. This can be addressed by moving the camera as the lighting changes or by adding

[Distance] and [Subject detection] to [Capture criteria].

Shake caused by the wind or other factors may trigger auto capture. This can be mitigated by

choosing higher values for [Speed]. It may also help to select [Normal] or [Sport] for [Vibration

reduction] in the photo shooting menu.

If you have [Subject detection] selected for [Capture criteria], try choosing a higher value for

[Subject Size]. If you chose the “auto” subject type, try a more specific option that matches your

subject instead.

Use [Target area] to restrict the target area.

If you know your subject will not appear again for a certain length of time after a burst ends, adjust

the wait between shots using [Timing options] > [Wait after shooting].

No Photos, or Fewer Photos Than Expected

[Motion] selected for [Capture criteria]:

Try selecting lower values for [Speed] and [Subject Size].

Subjects that are moving too quickly may not be detected. This effect can be mitigated by

choosing a wider angle.

If [Auto-area AF] is selected for AF-area mode, confirm that the target areas where the subject

appears have not been disabled using [Target area] (disabled target areas are displayed in red).

If you have [Subject detection] selected for [Capture criteria], try choosing a lower value for

[Subject Size].

If you have selected multiple [Capture criteria] conditions, try disabling all but one.

Problems and Solutions