Reference Guide (PDF Edition)

To view remote camera status, highlight [Remote camera list] on
the mast
er camera and press 2.
Remote cameras are identified by IP address.
Remote camera status is displayed as follows:
[Connected]: Normal connection.
[Busy]: The camera is being controlled from another master
camera.
[Error]: One of the following errors has been detected:
The remote camera standby timer has expired.
The remote camera is off.
The remote camera is not in the same group as the master
camera.
The IP address is incorrect.
[OFF]: Either
no remote camera has been assigned to the slot, or
[OFF] is selected for [Connect to remote camera] on the
camera in question.
Highlighting a remote camera with the [Connected] label and
pressing 2 displays the number of pictures awaiting upload
from the camera via FTP, FTP connection status, the battery level,
and the number of exposures remaining.
The entries for the remote cameras previously used for
synchronized release will show the time of the most recent shot.
-
-
-
-
-
-
-
-
-
-
Tip: Suspending Synchronized Release
To temporarily disable synchr
onized release without ending the camera’s connection to the network,
select [OFF] for [Connect to other cameras]> [Synchronized release] in the network menu.
Tip: Viewing Remote Camera Status
400
Synchronized Release