Reference Guide (PDF Edition)

C: Choose a channel for the WR-R11a/WR-R10.
Set the WR-R11a/WR-R10 channel selector to the desir
ed
channel.
C: Choose a link mode for the WR-R11a/WR-R10.
Select [Wireless remot
e (WR) options] > [Link mode] in the
camera setup menu and choose from the following options:
Option Description
[Pairing]
The camera connects only to devices with which it has pr
eviously been paired.
As camera will not communicate with devices with which it has not been
paired, this option can be used to prevent signal interference from other
devices in the vicinity.
Given that each device must be paired separately, however, PIN is
recommended when connecting to a large number of devices.
[PIN]
Communication is shared among all devices with the same four-digit PIN.
This option is a good choice for photography featuring a large number of
remote devices.
If there are multiple cameras present that share the same PIN, the flash units
will be under the sole control of the camera that connects first, preventing
all other cameras from connecting (the LEDs on the WR-R11a/WR-R10 units
connected to the affected cameras will blink).
414
Radio AWL
3
4