Manual cu modificările aduse de actualizarea firmware

To view remote camera status, go to [Connect to other cameras]>
[Gr
oup settings]> (group name) in the master camera network
menu, highlight [Remote camera list], and press 2.
To edit remote camera settings from the master camera, highlight
the camera in the remote camera list and pr
ess 2.
Tip: Suspending Synchronized Release
To temporarily disable synchr
onized release without ending the camera’s connection to the network,
select [OFF] for [Connect to other cameras]> [Synchronized release] in the network menu.
Tip: Viewing Remote Camera Status
Remote cameras are identified by IP address.
Remote camera status is displayed as follows:
[Connected]: Normal connection.
[Busy]: The camera is being controlled from another master camera.
[Error]: One of the following errors has been detected:
The remote camera standby timer has expired.
The remote camera is off.
The remote camera is not in the same group as the master camera.
The IP address is incorrect.
[OFF]: Either
no remote camera has been assigned to the slot, or
[OFF] is selected for [Connect to remote camera] for the camera in question.
Highlighting a remote camera with the [Connected] label and pressing 2 displays the number of
pictures awaiting upload from the camera via FTP, FTP connection status, the battery level, and the
number of exposures remaining.
The entries for the remote cameras previously used for synchronized release will show the time of
the most recent shot.
To temporarily suspend the connection to the selected camera, select [OFF] for [Connect to
remote camera].
To temporarily suspend synchronized release on the selected camera, select [OFF] for
[Synchronized release].
63
Changes to Synchronized Release
-
-
-
-
-
-
-
-
-
-
-
-