Manual cu modificările aduse de actualizarea firmware

Tip: Fine-Tuning the Distances for “Near” and “Far”
Fine-tuning is available exclusiv
ely with Nikon Z mount lenses, but not with the NIKKORZ
58mm f/0.95 S Noct.
Tip: The “Near” and “Far” Displays
The distances for [Near] and [Far] are displayed in meters only. They will not be displayed in
feet even when [Feet (ft)] is selected for [Distance units] in the setup menu.
Press the i button.
The camera will save the changes and return you to the auto capture settings display.
Pausing and Ending Auto Capture
To pause auto capture and return to the settings confirmation dialog, press the video-record button.
Auto capture can be resumed by pressing the button again.
To end auto capture and exit to the shooting display, press the O (Q) button.
D Cautions: Auto Capture
Image-area selection is fixed at [FX (36×24)]. Auto capture cannot be used when a DX lens is
attached.
During auto-capture standby, the camera focuses as described below.
[Capture criteria]> [Distance] enabled (M): The camera focuses at the distance selected for
[Far].
[Capture criteria]> [Distance] disabled (U): The camera focuses at the distance in effect when
auto capture began.
The camera may fail to detect subjects in the [Target area] when there are multiple subjects in the
frame.
Falling rain and snow may interfere with subject detection. Auto capture may be triggered by falling
snow, heat haze, or other weather phenomena.
D During Auto Capture
All controls other than the DISP, video-record, and O (Q) buttons are disabled while auto capture
shooting is in progress. End auto capture before attempting to adjust camera settings.
27
New Menu Item: “Auto Capture”
3
-
-