User's Manual
Table Of Contents
- Package Contents
- Table of Contents
- For Your Safety
- Notices
- Getting to Know the Camera
- First Steps
- Basic Photography and Playback
- Basic Settings
- Shooting Controls
- The i Menu
- Menu List
- Troubleshooting
- Technical Notes
- The Camera Display and Control Panel
- The Nikon Creative Lighting System
- Other Accessories
- Caring for the Camera
- Caring for the Camera and Battery: Cautions
- Specifications
- NIKKOR Z 24–70mm f/4 S Lens User’s Manual
- FTZ Mount Adapter User’s Manual
- Approved Memory Cards
- Memory Card Capacity
- Battery Endurance
- Notices
- Bluetooth and Wi-Fi (Wireless LAN)
- Index
188 Technical Notes
Wireless
remote
controllers
• WR-R10 Wireless Remote Controller/WR-T10 Wireless Remote
Controller: When a WR-R10 wireless remote controller is
attached to the accessory terminal, the camera can be
controlled wirelessly using a WR-T10 wireless remote
controller (when connecting the WR-R10, be sure the
cover for the accessory terminal and the USB and HDMI
connectors is fully open). The WR-R10 can also be used
to control radio-controlled flash units. For synchronized
release involving more than one camera, ready multiple
cameras with paired WR-R10 units attached.
• WR-1 Wireless Remote Controller: WR-1 units are used with
WR-R10 or WR-T10 wireless remote controllers or with
other WR-1 remote controllers, with the WR-1 units
functioning as either transmitters or receivers. As a
transmitter, the WR-1 can be used to control the camera
and take pictures via signals transmitted to a receiver (a
WR-R10 or a second WR-1) connected to the camera
accessory terminal, while as a receiver it receives remote
commands from a WR-T10 or a separate WR-1
transmitter.
Note: Be sure the firmware for the WR-R10 and WR-1 has been updated to
the latest version (WR-R10 firmware version 3.0 or later and WR-1 firmware
version 1.0.1 or later). For information on firmware updates, see the Nikon
website for your area. Consult a Nikon-authorized service representative
when updating the firmware for the WR-R10 from versions prior to version 2.0
to version 3.0 or later.
Viewfinder
eyepiece
accessories
DK-29 Rubber Eyecup: The DK-29 makes the image in the
viewfinder easier to see, preventing eye fatigue.