Reference Manual

247Menu Guide > C The Photo Shooting Menu
❚❚ No Photograph
Photographs will not be taken at the selected interval if the
current interval ends before the photograph or photographs for
the previous interval have been taken or the memory card is full.
D Out of Memory
If the memory card is full, the interval timer will remain active but no
pictures will be taken. Resume shooting after deleting some pictures
or turning the camera off and inserting another memory card.
D Interval Timer Photography
Choose an interval longer than the time needed to take the selected
number of shots and, if you are using a flash, the time needed for the
flash to charge. If the interval is too short, the number of photos taken
may be less than the total listed in Step 2 (the number of intervals
multiplied by the number of shots per interval) or the flash may fire at
less than the power needed for full exposure. Interval timer
photography will not start if the interval is set to 00:00’0.5” and both
Silent photography and Interval priority are enabled. Interval timer
photography cannot be combined with some camera features,
including movie recording, time-lapse movies, long time-exposures
(bulb or time photography), multiple exposure, and HDR (high
dynamic range). Note that because the shutter speed, frame rate, and
time needed to record images may vary from one interval to the next,
the time between the end of one interval and the beginning of the
next may vary. If shooting cannot proceed or changes cannot be
applied at current settings (for example, if a shutter speed of Bulb or
Time is currently selected in mode M, the interval is zero, or the start
time is in less than a minute), a warning will be displayed.
Interval timer shooting will pause when Self-timer (E) is selected for
release mode or if the camera is turned off and then on again (when
the camera is off, batteries and memory cards can be replaced without
ending interval timer photography). Pausing shooting does not affect
interval timer settings.