Owner's Manual

Page 18
Wireless Networking with Nikon Cameras
DR AFT #4
Proxy
Some networks use a “Proxy” server to further control access and security. If
your network uses one, enter it’s data here.
Advanced
The “Advanced” setting can be used to initiate a “PASV” or passive FTP transfer
and to specify a port to be used. This is only use on certain networks with a NAT
server. Check with your network administrator if having FTP problems and you
think that this option may be needed.
Other WT-1 Settings
The main “Wireless LAN” settings menu has several other settings which may be
useful.
Transceiver
This option can turn the WT-1 Transceiver On or Off. Turn the Transceiver “Off”
when making configuration changes or not transmitting images to conserve bat
-
tery.
Status
The Status menu will show the current connection status of the WT-1 to the wire-
less network, including signal strength and quality as well as number of frames
and approximate time remaining to complete the transfer.
Auto Send
Use the Auto Send menu option to turn on or off the automatic sending of images
to the FTP server. When “off” no images will be sent to the server until manually
begun.
Send file as
When shooting in the “RAW+JPEG” mode you can select to send via the wire
-
less connection either “JPEG only” or both the “NEF(RAW)+ JPEG”.
Send folder
An entire folder can be manually sent to the remote FTP server by using this op-
tion.
Deselect All
To stop sending images and clear the queue use this option to clear all pending
transfers.