Operation Manual

Using a Scanner with Windows XP (Home Edition /Professional)
xp-1
Registering a Scanner with Windows XP
(SUPER COOLSCAN 8000 ED / SUPER COOLSCAN 4000 ED /COOLSCAN IV ED
/ LS-2000 / COOLSCAN III)
Using a Scanner with Windows XP (Home Edition /Professional)
Step 1
The first time the scanner is connected to the computer, the “Found New
Hardware Wizard” will be displayed. Select Install from a list or spe-
cific location and click Next.
The screenshots in this manual show the registration procedure for the
SUPERCOOLSCAN 4000ED. The scanner must be registered as a hard-
ware device when it is connected to the computer for the first time.
You will need to log on as the “Computer Administrator” when registering
a scanner. Note that you should also log on as the “Computer Administra-
tor” when using, installing or uninstalling Nikon Scan.
Step 2
The dialog shown below will be displayed. Select Search for the best
driver in these locations, then check Include this location in the
search.
Caution (LS-2000 / COOLSCAN III Users)
You will need the Windows XP compatible ASPI layer for your SCSI board or SCSI
card in order to use the LS-2000 and the COOLSCAN III with Windows XP.