Operation Manual

147
Problem Possible Cause
Colors do not match the original.
111
118
112
63
46
39
60
—
• The monitor profile chosen in the Color Management tab of the Preferences
dialog does not match your monitor.
• The CMYK profile chosen in the Color Management tab of the Preferences
dialog does not match your printer.
• The RGB color-space profile chosen in the Color Management tab of the
Preferences dialog has too narrow a gamut (colors too vivid) or too wide a
gamut (image lacks contrast).
• Curves, color balance, or LCH settings are incorrectly adjusted.
• The resolution setting in the Crop palette does not suit the output device.
• You scanned negative media without performing an autoexposure operation.
• The Prescan Mode setting in the Scanner Extras palette (LS-2000/
COOLSCAN III only) requires adjustment.
• Monitor settings require adjustment.
The scanned image is too dark.
111
118
112
121
—
• The monitor profile chosen in the Color Management tab of the Preferences
dialog does not match your monitor.
• The CMYK profile chosen in the Color Management tab of the Preferences
dialog does not match your printer.
• The RGB color-space profile chosen in the Color Management tab of the
Preferences dialog has the wrong gamma value for your platform.
• You need to adjust the gamma value chosen in the Gamma tab of the Prefer-
ences dialog for use when Nikon CMS is off.
• The brightness setting on your monitor requires adjustment.
The scanned image has a rough,
jagged appearance.
• The resolution setting in the Crop palette does not suit the output device.
The scanned image has a rough,
jagged appearance.
46
85
• The resolution setting in the Crop palette does not suit the output device.
• The halo width or intensity settings in the Unsharp Mask palette are too high.
The file size is too large. 47• The value for resolution in the Crop palette is too high.
Appendix B: Troubleshooting