Reference Manual (complete instructions)

C-7
En-01
C
Flash Modes
■ Setting the flash output level
Highlight the flash output level, and then use the rotary multi selector to
change the flash output level.
• The flash output level changes in increments of 1/3 EV steps.
• When the rotary multi selector is rotated counterclockwise or the rotary
multi selector is pressed 3 4, the indicated denominator increases
(flash output level decreases). When the rotary multi selector is rotated
clockwise or the rotary multi selector is pressed 1 2, the indicated
denominator decreases (flash output level increases).
• With some cameras, and when using higher shutter speeds with a flash
output level higher than M1/2, actual flash output may decrease to
M1/2 level.
t When no lens aperture information is transmitted
Aperture; underlined when
aperture is set on the SB-5000
When lens aperture information is not
transmitted to the SB-5000, aperture
can be set in menu.