Reference Manual (complete instructions)
E-12
E
Functions
En-01
Setting the built-in wide panel
Carefully pull the built-in
wide panel all the way out and
position it over the flash
panel.
Slide the bounce card back into
place inside the flash head.
• To replace the built-in wide panel,
lift it up and slide it into the flash
head as far as it will go.
Zoom head position indicator
• When the built-in wide panel is
attached, the zoom head position is
automatically set depending on the
camera’s image area and illumination
pattern. The zoom head position is
set at 12 mm, 14mm or 17 mm in FX
format, and 8 mm, 10 mm or 11 mm
in DX format.
• The illumination pattern can be
changed in the setup menu (0B-24).