Product Manual
Table Of Contents
- Nikon XF Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting and Focusing
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless mode
- Setting Up the Prism Reflector
- External Device Connector
- Getting Started
- Checking and Adjustment
- System Diagrams
Nikon XF Series Total Station Instruction Manual vii
Safety
C
WARNING – Avoid contact with the rechargeable Lithium-ion battery if it appears to be leaking.
Battery fluid is corrosive, and contact with it can result in personal injury and/or property
damage.
To prevent injury or damage:
– If the battery leaks, avoid contact with the battery fluid.
– If battery fluid gets into your eyes, immediately rinse your eyes with clean water and seek
medical attention. Do not rub your eyes!
– If battery fluid gets onto your skin or clothing, immediately use clean water to wash off the
battery fluid.
C
WARNING – Charge and use the rechargeable Lithium-ion battery only in strict accordance
with the instructions. Charging or using the battery in unauthorized equipment can cause an
explosion or fire, and can result in personal injury and/or equipment damage.
To prevent injury or damage:
– Do not charge or use the battery if it appears to be damaged or leaking.
– Charge the Lithium-ion battery only in a product that is specified to charge it. Be sure to
follow all instructions that are provided with the battery charger.
– Discontinue charging a battery that gives off extreme heat or a burning odor.
– Use the battery only in equipment that is specified to use it.
– Use the battery only for its intended use and according to the instructions in the product
documentation.
Laser Safety
XF Series Total Station is a Class 2 Laser Product and XF HP Series Total Station is a
Class 3R Laser Product in accordance with: IEC60825-1:2014: “Safety of Laser
Products”
Precautions: To counteract hazards, it is essential for all users to pay careful attention
to the safety precautions and control measures specified in the standard IEC60825-
1:2014 within the hazard distance *); particularly on to “User’s Guide”.
Note – This product complies with IEC 60825-1:2014 and IEC 60825-1:2007 and 21
CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice no. 50.
dated June 24, 2007.
C
WARNING – Only qualified and trained persons should be assigned to install, adjust and
operate the laser equipment.
C
WARNING – Precautions should be taken to ensure that persons do not look directly, with or
without an optical instrument, into the beam.
C
WARNING – Laser beam path should be located well above or below eye level wherever
practicable.