Product Manual
Table Of Contents
- Nikon XF Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting and Focusing
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless mode
- Setting Up the Prism Reflector
- External Device Connector
- Getting Started
- Checking and Adjustment
- System Diagrams
Nikon XF Series Total Station Instruction Manual 33
Getting Started 3
Change PIN
To enable the security PIN Code or change the
PIN Code, tap [Change PIN] on the security
settings menu.
If the security PIN Code is already enabled, the
current PIN Code needs to be entered.
Enter the current PIN Code and tap [Accept]
button.
If you designate a new PIN Code, enter the new
PIN Code, and press [ ] or tap the next text
box. To confirm the input, enter the same PIN
Code, then tap [Accept] button.
The PIN Code is a four-digit number, e.g.
“1234”.
The default of PIN Code is “0000”. By default,
the security setting is not enabled and you will
not be prompted to enter the PIN Code when
starting the work.
Get PUK
To display PUK, tap [Get PUK] in the Security
settings menu.
If the wrong PIN Code is entered more than ten
times, you will be prompted to enter the PUK
Code.
When the correct PUK Code has been entered,
the PIN Code will be reset to “0000”.
This means that the PIN Code security will be
disabled. PIN Code security can be enabled
again using the Change Pin instructions above.