Product Manual
Table Of Contents
- Nikon XF Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting and Focusing
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless mode
- Setting Up the Prism Reflector
- External Device Connector
- Getting Started
- Checking and Adjustment
- System Diagrams
2 Preparation
22 Nikon XF Series Total Station Instruction Manual
Setting Up the Prism Reflector
1. Assemble the prism reflector as shown below.
2. Adjust the height of the tribrach adaptor (see page 23).
3. If necessary, change the direction of the prism (see page 23).
4. If you are using a single prism holder, set the position of the target plate (see
page 23).
Detailed instructions for Step 2 through Step 4 are provided on the following pages.
Note – The instrument must be used with the Tribrach W30S or W30Sb.
Tribrach
Tribrach
Tripod
Target plate for single prism
Tiltable single
prism holder
Prism C
Target pole
Triple prism holder
Height adjust-
ment adapter
is not used.
W30S/W30Sb
adapter 15