Product Manual
Table Of Contents
- Nikon XF Series Total Station Instruction Manual
- Legal Notices
- Safety
- Introduction
- Preparation
- Unpacking and Packing the Instrument
- Charging the Battery Pack
- Detaching and Re-Attaching the Battery Pack
- Setting Up the Tripod
- Centering
- Leveling
- Sighting and Focusing
- Setting the Measurement Mode and Preparing the Target
- Measurement in Reflectorless mode
- Setting Up the Prism Reflector
- External Device Connector
- Getting Started
- Checking and Adjustment
- System Diagrams
2 Preparation
12 Nikon XF Series Total Station Instruction Manual
C
WARNING – The battery is not itself waterproof. Do not get the battery wet when it is removed
from the instrument. If water seeps into the battery, it may cause a fire or burns.
Applying Power
• Plug in the charger to the supplied AC adapter to turn the unit on. The power
input must be 5 V with at least 4 A of current capability. Each battery may take
up to 2 A while charging.
Charging a battery
• Simply slide a battery into either battery slot to begin charging. The adjacent
charge indicator will illuminate yellow when charging is in progress. The
charge indicator will change to green when charging is complete.
• Charger slots are completely independent so a battery may be inserted
regardless of the state of the other battery slot.
• Charging may take 3-6 hours if the battery was normally discharged.
• Charging may take up to 7 hours with a completely drained battery which has
been stored for several months without use.
Charge indicator 1
Calibration
indicator 1
Calibration button
Calibration
indicator 2
Charge indicator 2
Power jack
This will read
5V, 4A
Case
“Top” edge
Battery Slot
1
Battery Slot
2