Quick Start Guide

2
Ⅰ
Ⅱ
Ⅲ
Ⅳ
Linear distance mode
Press POWER
button to measure
Keeping the button
pressed allows continuous
measurement of up to 20
seconds.
Horizontal distance
mode
Set your desired
mode.
Aim at the target.
Act
Ang
Hgt
Hor
Target point
Internal display (”Linear distance mode”)
(Display will be dierent depending on the setting mode.)
(Measurement order:
Ⅰ⇒Ⅱ⇒Ⅲ⇒Ⅳ⇒Ⅱ
, then repeat)
One-point (Act/Hor/Hgt/Ang) measurement
Height modeAngle mode
External display reading instructions
201.0
Hor
206.0
Act
45.2
Hgt
12.7̊
Ang
Act (Linear distance)
Hor (Horizontal distance)
Hgt (Height from horizontal)
Ang (Angle from horizontal)
All data below is displayed simultaneously.
En En
TO START:
1. Press POWER button to turn on.
2. Conrm your mode with the internal display (default is "last used" setting).
3. Set your desired mode and start measuring.
・
Target Priority modes
- Press and hold MODE button, then press and hold POWER button within 0.5 second.
Continue to press and hold both buttons (more than 2 seconds) until First Target
Priority mode and Distant Target Priority mode are switched.
* If the button is not pressed within 0.5 second, the display unit <m/yd./ft.> will be
switched.
: Distant Priority mode (factory setting)
: First Priority mode
MODE setting:
・
Measurement modes
-
Press and release MODE button.
Measurement mode changes in the order of 1 (Act) to 6 (Hor) as shown below.
Holding down MODE button longer switches the display unit.
1. Act: Linear distance
2. Hor (solid): Horizontal distance
3. Hgt (solid): Height from horizontal
4. Ang: Angle (degrees) from horizontal
5. Hgt (blinking): Vertical separation (height between two points)
6. Hor (blinking): Three-point measurement (height between two points)
・
Power turns o 30 seconds after the last operation.
Results display example
of each mode.
(Actual external display image)
Measurement Procedure Guide