Menu Guide

97Menu Guide
❚❚ Ending Shooting
To end shooting before all the photos are taken, highlight Off in
the time-lapse movie menu and press J, or press J between
frames. A movie will be created from the frames shot to the point
where shooting ended. Note that shooting will end and no
movie will be recorded if the power source is removed or
disconnected or the destination memory card is ejected.
❚❚ No Photograph
The camera will either end time-lapse recording (On selected
Interval priority) or skip to the next frame (Off selected
Interval priority) if it is unable to focus using autofocus (note
that the camera focuses again before each shot).
D Time-Lapse Movies
Time-lapse cannot be combined with some camera features, including
live view, movie recording, long time exposures (bulb or time
photography), the self-timer, bracketing (0 61), HDR (high dynamic
range; 0 69), multiple exposure (0 62), interval timer photography
(0 70), and focus shift (0 80). Note that because shutter speed and
the time needed to record the image to the memory card may vary
from shot to shot, the interval between a shot being recorded and the
start of the next shot may vary. Shooting will not begin if a time-lapse
movie cannot be recorded at current settings (for example, if the
memory card is full, the interval or shooting time is zero, or the interval
is longer than the shooting time).
Shooting may end if camera controls are used or settings are changed
or HDMI cable is connected. A movie will be created from the frames
shot to the point where shooting ended. To end shooting and record a
photograph, press the shutter-release button all the way down.