User Guide

- Ａ48 ･ -
VBA12001-R.3668.A
Outer LCD indication Set voltage of Stabilized power supply
①
7.80V
⑦
7.715±0.1V
②
7.415±0.1V
⑥
7.620±0.1V
③
7.320±0.1V
⑤
7.470±0.1V
④
7.170±0.1V
Blink
①
AE CCD alignment inspection and adjustment (ref. Page A27 for details
）
②
AE accuracy inspection and adjustment
③
Aperture accuracy inspection
④
Adjustment for battery check level (Use the battery tool (J15418) and stabilized power supply.
）
⑤
Built-in SB ash inspection and adjustment
〔Tools required〕ref. Page A41.
AE inspection and adjustment
・
Inspection on Battery check indications
After the battery check adjustment, input each voltage of the below into camera, and check the indications of the
outer LCD.
Note: Make an inspection by switching the voltage in the order of
①
-
⑦
.
・
Built-in SB ash inspection and adjustment
Set the distance between camera and ash meter to 1 m, and inspect and adjust the light volume of the built-
in SB. (ref. adjustment software for details)
①
AF accuracy inspection and adjustment (Make all the
following adjustments.)
②
YAW, PITCH inspection and adjustment
③
LARK adjustment (inc.
CCD output adjustment)
〔Tools required〕
1. When adjusting for all adjustment items
ref. Page A41.
2. When inspecting AF accuracy
① AF
adjustment lens (J18266)
②
AF adjusting tool (J15259
）
③
Lens holder for F4 (J15280)
④
AF chart
（J18344）
⑤
Chart illuminator for AF
（J15264）
3. When adjusting YAW, PITCH
YAW, PITCH tool
（
J18230
）
4. When adjusting LARK
The above tool when inspecting AF accuracy
Note:
When using the adjustment software for the rst time, prepare 5 cameras of D70s (or D70) and input the
average value of the 5 cameras, which was measured when checking the AF accuracy, in "WRITING OF AF
ADJ. LENS OFFSET VALUE" on the main menu.
AF inspection and adjustment