User Guide

- Ｄ1 ･ -

VBA12001-R.3668.A

Points to notice for Disassembly / Assembly

�

内部に高電圧部あり。カバーを外す時は感電に注意すること。

カバーを外した後は、修理指針の指示に従ってメインコンデン

サーの放電を必ず行うこと。

警告

Note:

①　

When disassembling/(re)assembling, be sure to use the conductive mat (J5033) and wrist strap (J5033-5)

for static protection of electrical parts.

②　

Before disassembling, be sure to remove batteries or AC power wires.

③　

When disassembling, make sure to memorize the processing state of wires and FPC, screws to be xed

and their types, etc. 　　　　

④　Because the low pass lter of the imaging CCD PCB is easily damaged, handle it with enough care.

Points to notice for Lead-free solder products

　・ Lead-free solder is used for this product.

　・ For soldering work, the special solder and soldering iron are required.

　・ Do NOT mix up lead-free solder with traditional solder.

WARNING

Due to an internal high voltage area,

take extra care not to

get an electric shock when detaching covers.

After removing covers, b

sure to discharge the main

condenser according to the instructions of repair manuals

Note:

When "Seprating Front and Rear bodies","Disassembling Image PCB",and"Disassembling Bayonet",

be sure to perform"Reset of AF defocus compensation amount"by D2X adjustment software after reassembly.