Digital Camera User Manual

:25 fS.6
eJ~ tt€9
(j}J ( IJ
~~_cffBI
Single Servo AF with Focus-Priority
For Single Servo AF with Focus-Priority, set the focus mode to
S.
You lightly press the shutter release button, the lens starts
adjusting for focus. Because the p'riority is on correct focus, the
shutter cannot be released until the subject is
in focus. After
focus is achieved, the focus remains locked for as long as the
shutter release button is lightly pressed. This feature
is useful,
especially when recomposing the picture with the mains
subject off center. However, if the camera-to-subject distance
changes, you have
to refocus.
36
Stationary subject is in
focus
With a st at ionary subjec t: Lightly press the shutter release
button. When the subject is
in focus, the lens stops moving, the
in-focus indication . appears
in the viewfinder, and focus is
locked.
If the subject moves, remove your finger from the
shutter release button, then lightly press
it again to re-start
autofocus.
When a stationary subject comes into focus, a double beep
sounds
(if set).
4 Subject is located closer than the closest focusing
distance
of the lens. Move away from subject and
refocus.
• Appears when TC-16A is used, alerting that the lens
focusing ring is not set at infinity
(00). Set focus mode
selector
to M, set lens focusing ring to 00, set focus
mode selector
to S again, then refocus.