Owner's Manual

Sub-command
dial
Flash Compensation
Flash compensation is used to alter flash output by from -3 EV to
+1 EV in increments of 1/
3
EV, changing the brightness of the main
subject relative
to the background. Flash output can be increased
to make the main subject appear brighter, or reduced to prevent
unwanted highlights or reflections.
Press the ~ button and rotate
the sub-command dial until the
desired value is displayed in the
control panel. In general, choose
positive values
to make the main
subject brighter, negative values
to make it darker.
At values
other than +0.0, a ~
icon will be displayed in the control panel and
viewfinder after you release the ~ button.
The current value for flash compensation can
be
confirmed by pressing the ~ button.
Normal flash output can be restored by
setting flash compensation to +0.0. Flash
compensation
is not reset when the camera is
turned off.
-~ ~]
+0 EV
(~ button pressed)
-ij ~]
-0.3 EV
-~ ~]
+1.0 EV
B Optional Flash Units
Flash compensation is also available with optional 58-900, 58-800, 58-600,
58-400, and 58-R200 flash units. The 58-900,58-800, and 58-600 also allow
flash compensation
to be set using the controls on the flash unit.
B See Also
For information on choosing the size of the increments available when
setting flash compensation, see Custom Setting b3 (Exp camp/fine
tune, 0 270).
177