Owner's Manual

Lowering the Built-in Flash
To save power when the flash is not in use,
press it gently downward until the latch
clicks
into place.
~ The Built-in Flash
Use with lenses with focal lengths of 24-300 mm in FX format (pg. 374).
Remove lens hoods
to prevent shadows. The flash has a minimum range
of 60 cm (2 ft.) and can not be used in the macro range of macro zoom
lenses.
If the flash fires in continuous release mode (pg. 86), only one picture will
be taken each
time the shutter-release button is pressed.
The shutter release may be briefly disabled
to protect the flash after it has
been used for several consecutive shots. The flash can be used again after
a short pause.
B1 See Also
See page 192 for information on locking flash value (FV) for a metered
subject before recomposing a photograph.
For
information on choosing a flash sync speed, see Custom Setting el
(Flash sync speed, pg. 305). For information on choosing the slowest
shutter speed available when using
the flash, see Custom Setting e2
(Flash shutter speed, pg. 308). For information on using the built-in flash
in
commander mode, see Custom Setting e3 (Flash cntrl for built-in
flash,
pg. 309).
See page 377 for information on using optional flash units. For
information on the range of the built-in flash, see page 427.
187