Owner's Manual

Ie'S fS,6 P 'so 200 P,. E
\ I 1
1 I \
Viewfinder
p
•
Ie'S FS.6
I
I 1>
\ I 1/
~P,-E T
l'im rl-ITpREI
'--------/-1)'
Control panel
,.
3 Select direct measurement mode.
Release the WB button briefly and then
press the button until the PRE icon in
the control panel and viewfinder start
to flash. A flashing F',- Ewill also appear
in
the control panel and viewfinder. At
default settings, the displays will flash
for about six seconds.
4 Measure white balance.
Before the indicators stop flashing, frame the
reference object so that it fills the viewfinder and
press
the shutter-release button all the way down. The camera
will measure a value for
white balance and store it in preset
d-O. No photograph will be recorded; white balance can be
measured accurately even when
the camera is not in focus.
5 Check the results.
If the camera was able to measure a
value for
white balance, Good will flash
in
the control panel, while the
viewfinder will show a flashing ['d. At
default settings,
the displays will flash
for
about six seconds.
;-_~ \ I /.' _
-Good--
I I \ \
D.-C
, , ~
PRE
Control panel
Gd P,. E
\11
1\\
Viewfinder
151