Owner's Manual

Table Of Contents
Tutorial
Photography
and
Playback
IIPoint-and-Shoot"
Photography
(AS
Mode)
This section describes
how
to
take photographs in
A~
(auto) mode,
an
automatic "point-
and-shoot"
mode
in
which the majority
of
settings
are
controlled by
the
camera in response
to
shooting conditions.
1 Turn
the
camera on.
1.1
Remove
the
lens cap and turn the camera on. The
moni-
tor
will turn on and the viewfinder display will light.
1.2
If
the
monitor
is
off
press
the
~
button
to
display shooting
information. Check the battery level
as
described below.
Monitor
Viewfinder
Description
fil
Battery fully charged.
c=:J
Battery partially discharged.
c=J
~
Low
battery.
Prepare
to charge battery.
.----J
~
Shutter
release
disabled.
Charge
battery.
(blTnKS)
(blinks)
If shooting information
is
not
displayed when the
~
button
is
pressed, the battery
is
exhausted. Charge the battery.
1.3
The
number
of
photographs
that
can be stored on
the
memory
card
is
shown
in
the shooting information display
and viewfinder. Check the
number
of
exposures remain-
ing.
If there
is
not
enough
memory
to
store additional
photo-
graphs at current settings, the display will flash
as
shown
at right. No further pictures can be taken until
the
mem-
ory card
has
been replaced or photographs have been
deleted (
20,
65).
2 Rotate
the
mode
dial
to
A~
(auto mode).
Tutorial:
"Point-and-Shoot"
Photography
e~
Mode)
I
1S