Owner's Manual

~ Before Using the Remote Control
Before using the remote control for the first time, remove the clear plastic battery-insulator
sheet.
II Cover the Viewfinder
When taking photos without your eye to the DK-20 rubber eyecup
viewfinder, remove the DK-20 rubber eyecup
(CD) and insert the supplied DK-S eyepiece cap
as shown (@). This prevents light entering via
the viewfinder interfering
with exposure. Hold
the camera firmly when removing
the rubber
eyecup.
~ Using the Built-in Flash
Before taking a photograph with the flash in P, S, A, M, or TI modes, press the ~ button to raise
the flash and wait for the ~ indicator to be displayed in the viewfinder (CD 20). Shooting will
be interrupted
if the flash is raised while a remote control mode is in effect or after the self- IQ~
timer has started. If the flash is required, the camera will only respond to the ML-L3 shutter-
release
button once the flash has charged. In auto or scene modes in which the flash pops
up automatically, the flash will begin charging when a remote control mode is selected; once
the flash
is charged, it will automatically pop up and fire when required. Note that only one
photograph will be taken when the flash fires, regardless
of the number of exposures
selected for Custom Setting
c3 (Self-timer).
In flash modes that support red-eye reduction, the red-eye reduction lamp will light for
about one second before
the shutter is released in quick-response remote mode. In delayed
remote mode, the self-timer lamp will light for
two seconds, followed by the red-eye
reduction lamp which
light for one second before the shutter is released.
• The ~ Button
Self-timer mode can also be selected by pressing the
~ button.
31