Owner's Manual

227
U
6 Compose the shot.
Compose the shot and arrange the flash units as shown below. Note that the
maximum distance at which the remote flash units can be placed may vary with
shooting conditions.
7 Set the remote flash units to the selected channel.
Turn all the remote flash units on and set them to the channel selected in
Step 4.
See the flash unit instruction manuals for details.
8 Raise the built-in flash.
Press the M button to raise the built-in flash. Note that even if –– is selected for
Built-in flash>Mode, the built-in flash must be raised so that monitor
preflashes will be emitted.
9 Frame the photograph, focus, and shoot.
After confirming that the camera flash-ready light and the flash-ready lights for
all other flash units are lit, frame the photograph, focus, and shoot.
FV lock
(0 149) can be used if desired.
60 ° or less
30 ° or less10 m/33 ft.
or less
30 ° or less
60 ° or less
5m/15ft.
or
less
5m/15ft.
or less
Camera
(built-in flash)
Wireless remote sensors
on flash units should face
camera.