Owner's Manual

II Removing Memory Cards
After confirming that the access lamp is off, turn the camera off,
open
the memory card slot cover, and press the card in to eject
it (CD). The card can then be removed by hand (@).
••
~ Memory Cards
• Memory cards may be hot after use. Observe due caution when removing memory cards
from the camera.
•
Memory cards that have been formatted in a computer or other device must be reformatted
in the camera before
they can be used for recording or playback.
• Turn
the power off before inserting or removing memory cards. Do not remove memory
cards from the camera, turn the camera off, or remove or disconnect the power source
during formatting or while data are being recorded, deleted, or copied to a computer.
Failure
to observe these precautions could result in loss of data or in damage to the camera
or card.
• Do
not touch the card terminals with your fingers or metal objects.
• Do
not bend, drop, or subject to strong physical shocks.
• Do
not apply force to the card casing. Failure to observe this precaution could damage the
card.
• Do
not expose to water, heat, high levels of humidity, or direct sunlight.
• No Memory Card
If no memory card is inserted, the control panel and viewfinder will
show (-
E-)and an icon will appear in the viewfinder as shown at
right.
Ifthe camera is turned off with a charged EN-EL3e battery and
no memory card inserted, (- E-)will be displayed in the control panel
and
an icon will be displayed in the viewfinder.
• The Write Protect Switch
Memory cards are equipped with a write protect switch to
prevent accidental loss of data. When this switch is in the
"lock" position, photos can
not be recorded or deleted and
the memory card can not be formatted. To unlock the
memory card, slide the switch to the "write" position.
~~2 ~~~
Write-protect switch
• See Also
See page 202 for information on formatting memory cards using the Format memory card
option in the setup menu.
31