Installation Manual

Installation Manual

This module is to be installed only by the professionals and used only with a Digital Camera

produced by Nikon Corporation. When this module is installed in the Digital Camera, we shall

consider the following points;

1. Since “2143EB

” owns its FCC ID Number/IC Number, we shall affix an exterior label on

the outside of the product if the FCC ID/IC Number is not visible. The exterior label shall

use wording such as either ”Contains Transmitter Module FCC ID: CGJ2143EB / IC

Number: 4634A-2143EB” or “Contains FCC ID: CGJ2143EB / IC: 4634A-2143EB”.

2. “2143EB” complies with requirements of sub-sections 15.19(a)(3) in FCC Rules Part 15

Subpart C. The manual statement (15.19 (a)(3) is included User Guide of the product.

3. “2143EB

” is to be installed only by the professional line operator as shown in following pictures.

(Fig1, 2, and 3)

Fig1. Front side of “2143EB

”

PAGE 1
Installation Manual This module is to be installed only by the professionals and used only with a Digital Camera produced by Nikon Corporation. When this module is installed in the Digital Camera, we shall consider the following points; 1. Since “2143EB” owns its FCC ID Number/IC Number, we shall affix an exterior label on the outside of the product if the FCC ID/IC Number is not visible.
PAGE 2
Fig2. Top view of “2143EB” be equipped for a digital camera (example) Connector Cable between Antenna and Module Antenna Module Fig3.
PAGE 3
There isn’t an official user manual for this Wireless LAN Module (2143EB). However, user manuals of final product which have the module, must contain notification corresponding to the following description. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.