User Manual

ManualsBrandsNikon ManualsElectronics802.11 b/g Transmitter Module

1

2

UJ-087 Embedded manual

Feeding power and the control are done from connector 14FHJ-SM1-GB made of JST that

exists in the module of Fig.1.

The voltage supplies DC3.3V±0.2V.

The control interface is SDIO.

The Pin layout is as shown in Fig.2.

Fig.1 module outline

1.GND

2.CLK

3.GND

4.CMD

5.DAT0

6.DAT1

7.DAT2

8.DAT3

9.VDD

10.VDD

11.VDD

12.GND

13.GND

14.DET

1.GND

2.CLK

3.GND

4.CMD

5.DAT0

6.DAT1

7.DAT2

8.DAT3

9.VDD

10.VDD

11.VDD

12.GND

13.GND

14.DET

TOP VIEW

Fig.2 PIN layout

Summary of content (3 pages)

PAGE 1
UJ-087 Embedded manual Feeding power and the control are done from connector 14FHJ-SM1-GB made of JST that exists in the module of Fig.1. The voltage supplies DC3.3V±0.2V. The control interface is SDIO. The Pin layout is as shown in Fig.2. Fig.1 module outline 1.GND 2.CLK 3.GND 4.CMD 5.DAT0 6.DAT1 7.DAT2 8.DAT3 9.VDD 10.VDD 11.VDD 12.GND 13.GND 14.DET Fig.
PAGE 2
There isn’t an official user manual for this Wireless LAN Module (UJ-087). However, user manuals of final products which have the module, must contain notification corresponding to the following description. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 3
For Mobile Products; This equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment should be installed and operated with at least 20cm and more between the radiator and person’s body (excluding extremities: hands, wrists, feet and legs). This device complies with Part 15 of the FCC Rules.