Reference Manual

128
The
c
/
E
(Release Mode/Self-Timer) Button
D
Burst Photography
•
Depending on shooting conditions and memory card performance, the
memory card access lamp may light for anywhere from a few tens of
seconds to around a minute. Do not remove the memory card while the
memory card access lamp is lit. Not only could any unrecorded images
be lost, but the camera or memory card could be damaged.
•
If the camera is switched off while the memory card access lamp is lit, it
will not power off until all images in the buffer have been recorded.
•
If the battery is exhausted while images remain in the buffer, the shutter
release will be disabled and the images transferred to the memory card.
D
Continuous H (Extended)
Depending on camera settings, exposure may vary erratically during each
burst. This can be prevented by locking exposure (
0
132).
D
The Memory Buffer
•
While the shutter-release button is pressed
halfway, the frame-count display will show
the number of pictures that can be stored in
the memory buffer.
•
When the buffer is full, the display will show
r00 and the frame rate will drop.
•
The number shown is approximate. The
actual number of photos that can be stored in the memory buffer varies
with camera settings and shooting conditions.