Owner's Manual

~ Metering Areas for FV Lock
The areas metered when FV lock is used with optional flash units are as
follows:
I
Picture taken with Flash control mode
'
Metered area
i-TTL
6-mm circle in center
of frame
Stand-alone flash unit
Auto aperture (@A)
Area metered by flash
exposure meter
Remote flash units
i-TTL
Entire frame
control led via
Auto aperture (@A)
Area metered by flash
Advanced Wireless
Lighting
Non-TTL auto (A)
exposure meter
~ Notes on Optional Flash Units
• Refer to the flash unit manual for detailed instructions.
• If the unit supports CLS, refer to the section on (LS-compatible digital
SLR cameras. This camera is not included in the "digital SLR" category in
the SB-80DX, SB-28DX, and SB - S0DX manuals.
• If the flash-ready indicator(~) flashes for about three seconds after a
photograph is taken in i-TTL or non - TTL auto mode, the flash has fired at
full power and the photograph may be underexposed ((LS-compatible
flash units only).
• i-TTL flash control can be used at ISO sensitivities between 100 and
12800.
• At ISO sensitivities over 12800, the desired results may not be achieved
at some ranges or aperture settings.
I
Technical Notes 159