Reference Manual

132 Recording and Viewing Movies
• Wind noise reduction: Select On to enable the low-cut filter
for the built-in microphone, reducing noise produced by wind
blowing over the microphone (note that other sounds may
also be affected).
• Manual movie settings: Choose On to allow manual
adjustments to shutter speed and ISO sensitivity when the
camera is in mode M. Shutter speed can be set to values as fast
as
1
/ 4000 s; the slowest speed available varies with the frame
rate:
1
/ 30 s for frame rates of 24p, 25p, and 30p,
1
/ 50 s for 50p, and
1
/ 60 s for 60p. If shutter speed is not in this range when live view
starts, it will automatically be set to a supported value, and
remain at this value when live view ends. Note that ISO
sensitivity is fixed at the value selected; the camera does not
adjust ISO sensitivity automatically when On is selected for
ISO sensitivity settings > Auto ISO sensitivity control in
the shooting menu (0 195).
1 Select Movie settings.
Highlight Movie settings in the
shooting menu and press 2.
2 Choose movie options.
Highlight the desired item and press
2, then highlight an option and press
J.
A HDMI
When the camera is attached to an HDMI video device, the video
device will display the view through the lens. If the device supports
HDMI-CEC, select Off for the HDMI > Device control option in the
setup menu (0 187) before shooting in live view.