Installation Guide

Wire Free Camera

NOTE: Each camera requires 2 rechargeable batteries, but can hold up to 4 batteries.

Quick Setup Guide

Hardware Setup

Scan to watch our

Setup Video

STOP: This camera is NOT for standalone use and MUST be paired to

the Night Owl WNIP2 Series Wi-Fi NVR. Only install a camera in its final

location AFTER it’s paired, and setup is completed.

Charge the camera(s) for at least 3 hours. Lift the rubber piece on the

camera's belly and connect the USB cable to the camera and a USB

power supply. Please ensure the batteries are installed or the camera(s)

will not charge.

Install the batteries. Press the button on the camera's belly to release

the battery cartridge and insert the batteries. Replace the cartridge

and connect the USB cable to the port under the rubber piece.

Scan the QR Code to watch the Setup Video on how to

pair your camera(s) to the Night Owl WNIP2 Series Wi-Fi

NVR (Wi-Fi NVR required for use).

PAGE 1
Quick Setup Guide Wire Free Camera STOP: This camera is NOT for standalone use and MUST be paired to the Night Owl WNIP2 Series Wi-Fi NVR. Only install a camera in its final location AFTER it’s paired, and setup is completed. Hardware Setup Install the batteries. Press the button on the camera's belly to release the battery cartridge and insert the batteries. Replace the cartridge and connect the USB cable to the port under the rubber piece.
PAGE 2
Quick Setup Guide Wire Free Camera Placing the Camera in Pairing Mode If the camera is not in pairing mode, press the button on the camera's belly to release the battery cartridge. Press and hold the reset button for 10 seconds or until the camera says, "Camera is in Pairing Mode." NOTE: The camera MUST be reset if it isn't paired to a Recorder within 2 minutes.