User Manual

46 WNVR Series User’s Manual
7.1.2 Network
Find network values and optimize connectivity based on your
Internet connection. In most cases the values should populate
automatically once your NVR is connected to the Internet. The
values in this section should only be adjusted if you are an advanced user and
have extensive experience in device networking.
DHCP: Network configuration mode that gathers the network values automatically
from DHCP server. If unchecked this value can be set manually.
IP Address: Network address of the connected NVR.
Subnet Mask: The range of IP addresses that can be found in the network. This
should always be set to the default address 255.255.255.000.
Gateway: The connection between two networks. This should always be the IP
address of the connected router.
MAC Address: The unique identifier assigned to network interfaces for
communications at the data link layer.
Preferred DNS: Domain Name System server address.
Web Port: Allows access to your NVR with your computer through your LAN or the
Internet. The default value is 80.
Network Bandwidth: Defines channel capacity, or the maximum throughput of the
network interface.
Net Diagnose Info: Allows you to Enable or Disable the network status availability.
Network Status: Shows status of the network connectivity.
ADVANCED